10 ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual
Chapter 2—Commands List
Direct Mode
Setup Commands
Used to set up the printer globally, that is, affect both the Direct Mode
and Forms.
D Density
eR User-Defined Error/Status Character Control
f Cut Position
I Character Set Selection
i Asian Character Spacing
JB Disable Top of Form Backup
JF Enable Top of Form Backup
j Media Feed Adjustment
O Options Select
oR Character Substitution
Q Set Form Length
q Set Label Width
R Set Reference Point
r Set Relative Reference Point
S Speed Select
SA Setup Adjust
SPC Setup Print Copy
SPR Setup Print Engine Ribbon Control
TD Set Date Format
TS Set Real Time Clock
TT Set Time Format
UC Command Reply Accept Character Control
UN Disable Error Reporting
US Enable Error Reporting
W Windows Mode
Y Serial Port Setup
Z Print Direction
Store Commands
GM Store Graphics in Memory
GW Store Graphics in Image Buffer
ES Store Soft Font
Clear and Delete Commands
Used to erase data from the printer’s memory.
EK Delete Soft Font
To Next Page
Loading...
Need help?
General
