Intermec EasyCoder PD4 Programmer's Reference Manual

ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual 61
Chapter 7—Commands
eR – User-Defined Error/Status Character Control
Description is command controls the format of error messages, mostly
when command US has enabled the printer’s status reporting fea-
ture, but also at some high priority error types when command
UN has disabled status report.
Syntax eRp
1
,p
2
[,p
3
]
Parameters p
1
Reply error action single character when error occurs:
Value of p
1
is one single ASCII-character, except hex 00. Default: 0
p
2
Mode of User Defined Error/Status Character reply (one ASCII-numerical):
p
2
= 0 Mode of Reply Default, where error number is NN:
Output at error action: <NAK>NN<XOFF>
Output at error recovery: <XON>
p
2
= 1 Mode of Reply only with character, defined by p
1
:
Output at error action: <p
1
><CRLF>
Output at error recovery: <p
3
><CRLF>
p
2
= 2 Mode of Reply with character p
1
and error number NN:
Output at error action: <p
1
>NN<CRLF>
Output at error recovery: <p
3
>00<CRLF>
p
2
= 6 Mode of <XOFF> and <XON> replacement:
Like default mode (0), but with all <XOFF> replaced by p
1
and all
<XON> replaced by optional p
3
:
Output at error action: <NAK>NN<p1>
Output at error recovery: <p
3
>NN
p
3
Optional recovery action single character:
The normal recovery character <XON> will be replaced by character p
3
.
Value of p
3
is one single ASCII-character, except hex 00.
If no p
3
is available, p
1
is used instead as recovery action character.
Remarks Exception of output: Error 07 “Out of media or ribbon”, is
added after 07 with Pnnn or Rnnn, where nnn = numbers of
remaining labels:
Output at error media action (mode 0):
<NAK>07Pnnn<XOFF>
Output at error ribbon action (mode 0):
<NAK>07Rnnn<XOFF>
Output at error recovery:
<XON>
Mode 1, 2 and 6 changes the output in a similar way.
All parameters are saved in Flash. If more than one error occur
at the same time, there will be an output for each error recovery,
like <p1>00<CRLF> on mode 2. Refer to Appendix A for
more information on error-handling.

Intermec EasyCoder PD4 Specifications

General

Brand	Intermec
Model	EasyCoder PD4
Category	Label Maker
Language	English