ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual 79
Chapter 7—Commands
JF – Enable Top of Form Backup
Description is command enables automatic top of form backup of the
media.
Syntax JF
Remarks Top of form backup is used in connection with the j command,
which makes the printer feed out an extra amount of media after
printing the label, as to allow the media to be torn, peeled, or cut
off properly.
By default, top of form is enabled, that is the media is pulled
back before printing the first label in next batch as to allow the
printing to start at the top of the label.
Top of form backup can be disabled by a JB command, that is,
any j command will be ignored, and the printer will stop feeding
when the end of the label becomes aligned with the printhead’s
dot line. In case of a cutter, the JB command must be preceeded
by an O command. However, the j command is kept stored in
memory and can be enabled again using a JF command.
Activating the cutter using an OC command has the same effect
as issuing a JF command.
Example JF↵ :Enables top of form backup
To Next Page
Loading...
Need help?
General
