ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual 125
Chapter 7—Commands
^default – Restore Factory Default
Description is command set all parameter back to the factory default.
Syntax ^default ↵
Remark Many recommendations, especially when troubleshooting or
updating firmware, require the need to start from a known
state. is command returns the printer to its default setup.
See Default Setup in Chapter 3, for the default value of setup
parameters. A delay of two seconds should be observed before
inputting other commands as the printer restarts after cleanup to
factory default.
Example Return to factory default setup.
^default↵
To Next Page
Loading...
