Intermec EasyCoder PD4 - 5 Printing

ESim v5.12 for EasyCoder PD4—Programmer’s Reference Manual 37
Chapter 7—Commands
B – Standard Bar Codes
Description is command is used to print standard bar codes.
Syntax Bp
1
,p
2
,p
3
,p
4
,p
5
,p
6
,p
7
,p
8
,"DATA"
Parameters p
1
Horizontal start position (X) in dots.
p
2
Vertical start position (Y) in dots.
p
3
0 No rotation.
1 90 degrees rotation clockwise.
2 180 degrees rotation clockwise.
3 270 degrees rotation clockwise.
p
4
Bar code select. See Bar Code Type table below.
p
5
Narrow bar width in dots. See Bar Code Type table below.
Bar Code Type "p
4
" "p
5
"
Code 39 std. or extended 3 1-10
Code 39 with check digit 3C 1-10
Code 93 9 1-10
Code 128 UCC case code 0 1-10
Code 128 A, B, C 1 1-10
Codabar K 1-10
EAN8 E80 2-4
EAN8 2 digit add-on E82 2-4
EAN8 5 digit add-on E85 2-4
EAN13 E30 2-4
EAN 13 2 digit add-on 32 2-4
EAN13 5 digit add-on E35 2-4
Interleaved 2 of 5 2 1-10
Interleaved 2 of 5 with check digit 2C 1-10
Interleaved 2 of 5 w human readable check digit 2D 1-10
Postnet 5, 6, 8 & 11 digit P n.a.
UCC/EAN 128 1E 1-10
UPC A UA0 2-4
UPC A 2 digit add-on UA2 2-4
UPC A 5 digit add-on UA5 2-4
UPC E UE0 2-4
UPC E 2 digit add-on UE2 2-4
UPC E 5 digit add-on UE5 2-4
UPC SCC 2U 1-10
p
6
Wide bar width in dots (2 -30).
p
7
Barcode height in dots.
p
8
B Human readables ON.
N Human readables OFF.
"DATA" Represents a fixed data field.