Intermec SG20B - Handling Damaged 1 D Bar Codes; Predefined Imager Modes

Appendix B — Optimizing Scanner Performance
98 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
Optimizing Decoding
Use the following barcodes to optimize your scanner reading
performance.
Damaged 1-Dimensional Bar Codes
If you are reading 1D bar codes that are damaged or badly printed,
enable this setting to enhance the ability to read these types of bar
codes.
Damaged 1D Codes - Enable
Damaged 1D Codes - Disable (*)
Predefined Imager Modes
When using a 2D model (SG20BHP or SG20BHPHC), you can
optimize the reading performance of the scanner by adjusting certain
parameters. Since there are many parameters that can be adjusted, we
recommend using the pre-defined imager settings to quickly set up
your imager for optimized reading. The pre-defined imager settings
take in to account the type of bar code, environment and reading
surface.
There are 4 pre-defined imager settings:
• 1-Dimensional bar codes only
• Standard 1-dimensional and 2-dimensional bar codes
• 1-Dimensional and 2-dimensional bar codes in a bright
environment
• 1-Dimensional and 2-dimensional bar codes with reflective
surface (shiny labels and cell phone scanning)
Note: These configuration bar codes are only for the SG20BHP and
SG20BHPHC models.