Intermec SG20B - Configuring the SG20 B in Direct Connection

Chapter 5 — Connect and Configure the SG20B Scanner in Direct Connection
58 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
Configure the SG20B in Direct Connection
This section provides you with configuration bar codes for a basic
setup of your scanner. It also gives the procedure for configuring your
scanner in direct connection using EasySet.
Basic Setup with Configuration Bar Codes
These configuration bar codes apply when your scanner is connected
to a host in direct connection only.
All default values are marked with (*).
Reset Your Scanner
To reset your scanner, read the reset factory defaults configuration
bar code.
Reset factory defaults
Set an International Keyboard
By default the SG20B uses a North American keyboard layout. Use
these configuration bar codes to select the keyboard for your country.
Additional keyboards are available in EasySet (see
“Configuring
Your System with EasySet” on page 31).
North American Windows (*)
French Windows
French Canadian Windows 95/98