Chapter 3 — Connect the Scanner and Base Station as a System
36 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
Bluetooth Connected—Intermec-Ready-to-Work Indicator On
Your scanner is ready to scan data.
Out of Range Behavior
If the Bluetooth connection is lost (out of range, scanner battery too
low, etc.) the scanner and base station will automatically try to
reconnect once the problem is resolved (back in to range, recharge
scanner battery, etc.). If you try to read a bar code while the scanner is
disconnected from the base station, the scanner will emit an error
beep.
No data is stored in the buffer, meaning that no data can be lost when
the scanner looses connection with the base station.
Note: If you cannot read the association bar code located on the
bottom of the base station you will need to create an association bar
code using EasySet, see “Configure Your System with EasySet” on
page 47.
To Next Page
Loading...
