EasyManuals Logo

Intermec SG20B User Manual

Intermec SG20B
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Chapter 3 — Connect the Scanner and Base Station as a System
32 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
The SG20 Bluetooth Base Station is successfully connected and
power is on when it emits 2 blue flashes.
5 If necessary, configure the serial parameters of your base station
using EasySet to match the host device (for more information on
serial parameters setup, see “RS-232 Interface Settings” on
page 43).
Keyboard Wedge Interface
For a keyboard wedge interface the keyboard wedge Y-cable is
connected to the 10-pin modular connector. If your host does not
provide enough power you can connect an external power supply to
the Y-cable. This will power your base station but will not provide
enough power to charge a scanner in the base. To charge a scanner
(fast charge) you must connect an external power supply to the DC
connector.
To connect with a keyboard wedge Y-cable
1 Turn off your host device.
2 Connect the Y-cable to the 10-pin modular connector of your base
station and to the host device (one end to the host and the other to
a PS2 keyboard).
Do not connect a keyboard wedge Y-cable to a host that is
turned on. You may damage your product.

Table of Contents

Other manuals for Intermec SG20B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intermec SG20B and is the answer not in the manual?

Intermec SG20B Specifications

General IconGeneral
BrandIntermec
ModelSG20B
CategoryBarcode Reader
LanguageEnglish

Related product manuals