Chapter 4 — Configure the Scanner and Base Station as a System
48 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
Offline Setup with EasySet
To configure your system offline by scanning bar codes
1 Start EasySet. The first time you start EasySet, the Select product
dialog box appears.
If the Select product dialog box does not appear, choose Product
> Select or click on the product icon in the upper left corner.
2 Select your product (SG20BSYS).
3 Open the folders to find the configuration commands needed.
Double-click each command to send each command to the setup
sheet.
4 Click on the print icon to print out the setup sheet and scan the
commands.
Note: The scanner does not beep when you send configuration
commands online from EasySet. When you select Disconnect from
the Communication menu in Easyset, the base station reboots and
the scanner disconnects then reconnects to it.
To Next Page
Loading...
