Chapter 6 — Troubleshoot and Maintain the Scanner and Base Station
SG20B Scanner + Bluetooth Base Station User’s Guide 83
Replace the SG20B Scanner Battery
If your scanner flashes a battery fault signal (blinking amber LED), it
is possible to order a new battery pack (P/N BP-SG20-xxx) and replace
the defective battery by the new one.
Always fully charge a new battery in your SG20B scanner before using
it. Batteries can be charged after a partial discharge without affecting
the original battery capacity. A fully discharged battery charges in
approximately 3 hours.
You can charge the battery with one of these accessories:
• SG20B Charge Base (P/N CB-SG20-xxx)
• SG20 Bluetooth Base Station (P/N BB-SG20-xxx)
Intermec Technologies Corp.
Everett, WA 98203
BDA: XXXXXXXXXXXXXXX
CN: SG20T1D-XXXXXX
12584563214587
Contains TX FCC ID: HN2-BTM311
MEX SCT RCPACBT05-068
IC: ICES-003 CLASS B
IC: 1223A-BTM311
ANATEL: 1192-06-0569
ݭɼ૦ծ
MODEL, , : SG20
5V 1.7A
Made in Singapore
MFD , : YY/MM/DD
Intermec Technologies Corp.
Everett, WA 98203
BDA: XXXXXXXXXXXXXXX
12584563214587
IC: ICES-003 CLASS B
MFD , : YY/MM/DD
MODEL, , : SG20B
5V 1.7A
Made in Singapore
ݭɼ૦ծ
Reset Button
CN: SG20B1D-XXXXXX
Note: Intermec recommends that the battery be changed by a certified
technician.
To Next Page
Loading...
Need help?
General
