Chapter 1 — About the SG20B Cordless Scanner
SG20B Cordless Scanner + Bluetooth Base Station User’s Guide 11
Understand the Lights
The status light and Intermec Ready-to-Work indicator on the SG20B
flash red, green, amber and/or blue depending on the status of the
scanner, battery and Bluetooth connection.
Intermec Ready-to-Work Indicator
The Intermec-Ready-to-Work indicator ™ (blue LED) gives
information about the Bluetooth connection. When a connection has
been established the light is always on (blue) unless the scanner is
docked in a Base station or charge base. In this case the blue light
turns off even though the Bluetooth connection is still active.
When using your scanner to scan bar codes (blue light on) your
scanner will also flash status information using green, red and amber
lights. See the Status Light information in the next section.
Blue Intermec Ready-to-Work Indicator
Light State What it Means
Off A Bluetooth connection has not been established.
OR
Scanner is docked in a base station or charge base
(Bluetooth connection is active - check host to verify
connection).
Blinking, slow The scanner is trying to establish a Bluetooth
connection with a Bluetooth device.
Blinking, fast The scanner is awaiting user acknowledgement in a
pairing procedure.
On A Bluetooth connection to the base station or host
computer is established. The SG20B is ready to scan
bar codes and send data.
To Next Page
Loading...
Need help?
General
