Chapter 3 — Connect the Scanner and Base Station as a System
30 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
Connect to the 10-Pin Modular Connector
Use an Intermec SG20 USB cable to connect from the 10-pin modular
connector of the base station to the USB port of your host.
An external power supply to the DC connector is required.
To connect a USB cable to the 10-pin modular connector
1 Connect an Intermec SG20 USB cable to the 10-pin modular
connector of the base station and to the host.
SG20 Bluetooth Base Station USB Connection on 10-pin Modular
Connector
2 Connect the power supply to the DC connector and to an AC
power outlet.
3 If the host is turned off, turn it on. The SG20 Bluetooth Base
Station is successfully connected and power is on when it emits 2
blue flashes.
4 If necessary, configure your SG20 Bluetooth Base Station for an
International keyboard using EasySet. The default keyboard is
North America (for additional keyboards, see “International
Keyboard” on page 41).
10-pin modular connector
x 2
SG20 USB cable
External
power supply
To Next Page
Loading...
