Intermec SG20B - Page 41

Chapter 3 — Connect the Scanner and Base Station as a System
SG20B Cordless Scanner + Bluetooth Base Station User’s Guide 29
To connect a USB cable to the USB connector
1 Connect a standard USB cable to the USB connector of the base
station and to the host.
SG20 Bluetooth Base Station USB Connection on USB Connector
2 Connect the power supply (optional) to the DC connector and to
an AC power outlet.
3 If your host device is off, turn it on. The SG20 Bluetooth Base
Station is successfully connected and power is on when the blue
light flashes 2 times.
4 If necessary, configure your SG20 Bluetooth Base Station for an
International keyboard using EasySet. The default keyboard is
North America (for additional keyboards, see “International
Keyboard” on page 41).
USB connector
Standard
USB cable
x 2
DC connector
Optional external
power supply
Note: If you do not use an external power supply you may get a
message that the host does not provide enough power. In this case
use a different hub or disconnect other USB devices. The host
must provide 500mA from the USB port to power the base station
and charge a scanner by slow charge.