Chapter 3 — Connect the Scanner and Base Station as a System
34 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
Connect the SG20B Scanner to a SG20 Bluetooth
Base Station
You can use Bluetooth radio communication to connect your SG20B
scanner to the SG20 Bluetooth Base Station.
When your base station is connected to your host and your scanner is
connected to your base station, they can be seen together as a single
system, such as a tethered scanner.
To connect a scanner to the base station
1 Connect the SG20 Bluetooth Base Station to a host device using
the correct cable for your interface (see “Connect the SG20
Bluetooth Base Station to a Host” on page 28).
2 Turn your SG20B on by pressing the trigger.
3 Read the Bluetooth association bar code on the bottom of the
SG20 Bluetooth Base Station.
To Next Page
Loading...
