Chapter 1 — About the SG20B Cordless Scanner
SG20B Cordless Scanner + Bluetooth Base Station User’s Guide 9
To scan with a 2D imager
1 Turn on your scanner by pressing the trigger.
2 Connect your scanner to a SG20 Base Station or to another
Bluetooth device.
3 Point the scanner window at the bar code label and hold the
SG20B steady a few inches from the label.
4 Pull the trigger and use the laser framing to position the imager
over the bar code or area to capture.
Example: SG20THP Laser Framing
By default, when the SG20B successfully scans a bar code, the
SG20B beeps one time, the status light turns green for 2 seconds,
and the scanner lighting turns off.
5 Release the trigger.
Hands-Free Scanning
The SG20B is a handheld scanner however you can scan items
without having to hold your scanner in your hand. To do hands-free
scanning, you will need to change the triggering mode to Autostand.
To activate, see
“Hands-Free Scanning” on page 99.
Note: When bar code labels are printed close to each other, try to
frame only the bar code you want to read, to avoid reading the wrong
bar code.
To Next Page
Loading...
Need help?
General
