Chapter 5 — Connect and Configure the SG20B Scanner in Direct Connection
SG20B Cordless Scanner + Bluetooth Base Station User’s Guide 53
Before trying to pair or connect your scanner, make sure:
• it is not already trying to establish a Bluetooth connection. If so,
the blue Intermec Ready-to-Work indicator blinks; read the
Bluetooth device disconnect bar code.
Bluetooth Device Disconnect
• it is not already paired with your Bluetooth device. If so, remove it
from your host’s Bluetooth devices list.
• your host is set to allow Bluetooth device connections.
SPP Outgoing Connection (Host Initiated)
A host-initiated (Outgoing) SPP connection requires opening the
Outgoing virtual COM port from your host application (EasySet or a
terminal emulation program for example).
The advantage of this method is that no Bluetooth association bar
code is required but if the connection with the host is lost, you must
reconnect by re-opening the COM port.
To connect in SPP device profile—outgoing connection
1 Turn on your scanner by pulling the trigger.
2 Scan the Bluetooth device profile - SPP configuration bar code
Bluetooth Device Profile - SPP (*)
3 Pair the scanner with your device:
• Double-click the Bluetooth icon on your taskbar. The
Bluetooth Devices window appears.
• Click on the command for adding a Bluetooth device (Add or
Add a device depending on operating systems). The wizard for
adding Bluetooth devices appears.
Follow the on screen instructions until your host searches for
Bluetooth devices. The SG20B scanner appears in the
Bluetooth device list in the following format: SG20B - BDA,
To Next Page
Loading...
