Chapter 4 — Configure the Scanner and Base Station as a System
SG20B Cordless Scanner + Bluetooth Base Station User’s Guide 45
Configure the Postamble
The default postamble is <CR> <LF> for the scanner and None for the
base station. For certain applications or when using USB Keyboard
HID you may need to change this setting. You can set a postamble for
the scanner as well as for the base station.
Data are transmitted as follows with a postamble and/or preamble:
[Preamble - Base station][Preamble - Scanner][Data][Postamble -
Scanner][Postamble - Base station].
Postamble configuration bar codes - Scanner
Use the following configuration bar codes to change the default
postamble at scanner level.
Carriage Return + Line Feed (*) - Scanner
None - Scanner
Carriage Return - Scanner
Enter - Scanner
To Next Page
Loading...
