Chapter 5 — Connect and Configure the SG20B Scanner in Direct Connection
52 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
6 Select your scanner and validate.
7 If a PIN is required (depending on your host operating system and
Bluetooth version), enter the default Bluetooth PIN (0000) and
validate. The blue Intermec Ready-to-Work indicator starts
blinking rapidly, indicating that the scanner is awaiting
acknowledgment.
8 Pull the trigger.
Your scanner is paired and automatically connects to the host. It
emits a series of beeps from low to high, and the blue Intermec
Ready-to-Work indicator turns solid blue.
To Disconnect From the Host
To disconnect from the host, scan the disconnect bar code:
Bluetooth Device Disconnect
Check that the scanner is no longer in the host’s device list. If
necessary, manually remove the scanner from the list
SPP Bluetooth Device Connection
The SPP profile allows your SG20B to use the Bluetooth link as a
serial port to communicate with your host device. If you are using an
application working with serial ports, you do not need to modify it to
collect data with the SG20B.
You can connect your scanner to your host using one of the following
connections:
• SPP outgoing connection (host initiated)
• SPP incoming connection (scanner initiated)
To Next Page
Loading...
