Intermec SG20B User Manual

Chapter 1 — About the SG20B Cordless Scanner
SG20B Cordless Scanner + Bluetooth Base Station User’s Guide 5
For more information on connecting the charge base see the SG20B
Charge Base Instructions delivered in the box with your charge base.
For more information on charging times using the base station see
“Understand the Ports” on page 21.
Check Battery Status
When the battery capacity remaining is lower than 20% the scanner
status light flashes red approximately every 2 seconds. This means
you need to charge the battery.
If your scanner is off, pull the trigger to turn it on to see the battery
status.
Turn on the SG20B
Use the trigger to turn on the SG20B.
To turn on the SG20B
• Pull the trigger.
When you pull the trigger to turn on the SG20B, the scanner enters a
discoverable state and remains discoverable for 5 minutes (before
automatically shutting off, can be configured). While the SG20B is
discoverable and in communications range, your host Bluetooth
device can discover your SG20B and establish a Bluetooth connection.
If your SG20B is already connected to a Bluetooth device (blue
Intermec Ready-to-Work indicator on), it is not discoverable.
If the status light on the SG20B flashes red when you pull the trigger
to turn it on, you need to charge the battery.
SG20 Base Station Charging Times
USB Connector 10-Pin Modular Connector DC Connector
Slow charge Fast charge Fast charge

Intermec SG20B Specifications

General

Brand	Intermec
Model	SG20B
Category	Barcode Reader
Language	English