Chapter 5 — Connect and Configure the SG20B Scanner in Direct Connection
SG20B Cordless Scanner + Bluetooth Base Station User’s Guide 57
5 Read the Bluetooth connection bar code. You may be able to read
it on the screen in EasySet, if not you can print it out as a label and
perhaps stick it on your host device where it is easy to read
(suggestion).
The blue Intermec Ready-to-Work indicator blinks slowly for 5
minutes to indicate it is waiting to connect (default scanner
behavior).
6 Start the host application you want to connect to and open the
Incoming COM port you noted previously.
If a PIN is required (depending on your host operating system and
Bluetooth version), enter the default Bluetooth PIN (0000) and
validate. The blue Intermec Ready-to-Work indicator starts
blinking rapidly, indicating that the scanner is awaiting
acknowledgment.
7 Pull the trigger.
When the scanner connects to your host application, it emits a
series of beeps from low to high, and the blue Intermec Ready-to-
Work indicator turns solid blue (default scanner behavior).
To Disconnect From the Host
Use the Bluetooth disconnect procedure specific to your host
application to close the Incoming COM port.
When the scanner disconnects from the host PC, it emits a
“disconnect successful” beep sequence (series of beeps from high to
low), and the blue Intermec Ready-to-Work indicator blinks slowly for
5 minutes to indicate it is waiting to connect (default scanner
behavior).
When you open the Incoming COM port again, if the scanner is
switched on it will reconnect to the host application.
To Next Page
Loading...
