Chapter 5 — Connect and Configure the SG20B Scanner in Direct Connection
56 SG20B Cordless Scanner + Bluetooth Base Station User’s Guide
To connect in SPP device profile—incoming connection
1 Turn the scanner on by pulling the trigger.
2 Scan the Bluetooth device profile - SPP configuration bar code
Bluetooth Device Profile - SPP (*)
3 Make sure that your host is enabled for Bluetooth connection
from an external device (your SG20B).
• Right-click the Bluetooth icon in the Windows system tray and
choose Open Settings (or its equivalent).
A Bluetooth settings window is displayed.
• Under the Options tab (or equivalent), activate the following
options or their equivalents:
Allow Bluetooth devices to connect to this computer
Alert me when a new Bluetooth device wants to connect
• Under the COM Ports tab (or equivalent):
Note the host computer’s Incoming COM port. If there is no
incoming COM port, you must create one.
• Under the Hardware tab (or equivalent):
Select Properties > Advanced and note the host computer’s
Bluetooth address.
4 Create a Bluetooth connection bar code in EasySet
• Start EasySet version 5.6.5.4 or later. Make sure that SG20B is
selected as your product.
• Select the Interface > Bluetooth > Connection > Bluetooth
Quick Connect folder.
• Double-click on the Compose BT address command. A
Bluetooth - Connect/disconnect - Compose BT address
window opens.
• Compose your host Bluetooth Device Address (BDA) and click
OK. The Bluetooth association bar code is created.
To Next Page
Loading...
