SECTION 6 " PEN*KEY 6400 Computer
6-18 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
THE WINDOW DISPLAY MODE
ALLOWS THE COMPUTER
USER TO VIEW ANY PART
OF THE ACTUAL VT220 SCREEN
AND TO MOVE ABOUT THE
VT220 SCREEN USING THE
CURSOR CONTROL KEY.
INDOW DISPLA
S THE COMPUT
TO VIEW ANY
E ACTUAL VT2
O MOVE ABOUT
VT220 Terminal
PEN*KEY 6400
Computer
Figure 6-3
PEN*KEY 6400 Windowing Mode
If you try to move the cursor off the display in any direction,
the window shifts one or eight lines or columns in the direc-
tion of the cursor movement. This lets you move the view-
ing window around within the larger VT220 terminal
screen. The display does not wrap when the window reach-
es the top or side boundaries of the virtual VT220 screen. A
beep tone sounds when you try to move the window beyond
a top, bottom, left, or right boundary.
Use the arrow keys in combination with [GOLD] and
[BLUE] to move through the PEN*KEY computer’s display
a single space at a time or eight spaces at a time. The fol-
lowing chart shows key movements.
To Next Page
Loading...