SECTION 6 " PEN*KEY 6400 Computer
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 6-23
Table 6-10
PEN*KEY 6400 Control Keys (41-Key Keyboard)
To Do Standard Mode Alpha Lock Mode
CTRL A--
CTRL I
[CTRL]+[BLUE]+[1] --
[CTRL]+[BLUE]+[9]
[BLUE]+[CTRL]+[1] --
[BLUE]+[CTRL]+[9]
CTRL J--
CTRL V
[CTRL]+[BLUE]+[0] --
[CTRL]+[BLUE]+[F12]
[BLUE]+[CTRL]+[0] --
[BLUE]+[CTRL]+[F12]
CTRL W [CTRL]+[BLUE]+[CTRL] [BLUE]+[CTRL]+[CTRL]
CTRL X [CTRL]+[BLUE]+[%] [BLUE]+[CTRL]+[%]
CTRL Y [CTRL]+[BLUE]+[$] [BLUE]+[CTRL]+[$]
CTRL Z [CTRL]+[BLUE]+[:] [BLUE]+[CTRL]+[:]
Transmission Mode
Use the transmission mode (labeled “mode” on the overlay)
to put the PEN*KEY computer into line edit (block) mode or
character mode. To alternate between modes, press
[GOLD]+[1] on both keyboards.
When “lock mode” is disabled through the firmware menus,
you can press the mode key to toggle between line edit
mode and character mode. When lock mode is enabled, you
cannot toggle between line edit (block) mode and character
mode. The default setting is “disabled.”
The modes are described on pages 8-55 and 8-56 in Section
8, “Programming.”
To Next Page
Loading...