Intermec VT220/ANSI - Selected Area Transfer Mode (SATM)

SECTION 8 " Programming
8-64 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
Table 8-44
Guarded Area Transfer Modes
Mode Sequence* Wireless Station Action
Set
(All)
CSI 1 h Selects all characters. During
block transmission, the wireless
station can send all protected
and unprotected characters to
the host.
Reset
(Unprotected)
CSI 1 l Selects unprotected characters.
During a block transmission, the
wireless station can send only
unprotected characters to the
host.
* The last character of the reset mode sequence is lowercase L
(6C hexadecimal).
Selected Area Transfer Mode (SATM)
The selected area transfer mode control function deter-
mines whether the wireless station can send all characters
or only selected characters to the host. Selected characters
are characters defined as eligible to send to the host.
Table 8-45 lists selected area transfer modes.
Table 8-45
Selected Area Transfer Modes
Mode Sequence* Wireless Station Action
Set
(All)
CSI 1 7 h Selects all characters. The wire-
less station can send selected
and unselected characters on the
current page to the host.
Reset
(Unprotected)
CSI 1 7 l Selects only selected characters.
The wireless station can only
send selected characters on the
current page to the host.
* The last character of the reset mode sequence is lowercase L
(6C hexadecimal).