Intermec VT220/ANSI - Character Set Selection; Designating Hard Character Sets

SECTION 8 " Programming
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 8-15
Character Set Selection
The wireless station supports hard character sets. It does
not support designating soft (down-line loadable) character
sets.
Designating Hard Character Sets
Designate hard character sets using the escape sequence
format in Table 8-8.
Table 8-8
Hard Character Set Escape Sequences
Escape Sequence Designated As
Supplemental and special graphics sets:
1B hexadecimal 28 hexadecimal
ESC ( (Final)
1B hexadecimal 29 hexadecimal
ESC ) (Final)
1B hexadecimal 2A hexadecimal
ESC * (Final)
1B hexadecimal 2B hexadecimal
ESC + (Final)
NRC sets:
1B hexadecimal 2D hexadecimal
ESC -- (Final)
1B hexadecimal 2E hexadecimal
ESC . (Final)
1B hexadecimal 2F hexadecimal
ESC / (Final)
G0
G1
G2
G3
G1
G2
G3
The final character in the escape sequence represents the
character set you want to designate. For the wireless sta-
tion, the final characters are indicated in Table 8-9.