SECTION 1 " Introduction
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 1-3
If your radio network has not yet been installed, read first
the installation and operations guide provided with your
software. The guide describes how to install the hardware
and software, and then configure the software according to
the requirements of your site.
Organization of this Guide
This guide is divided into sections that specifically address
the operation and programming of wireless stations. This
Introduction contains a brief overview of this programmer’s
guide. Sections 2 through 7 describe how the wireless sta-
tions’ annunciators and keyboards emulate VT220 terminal
operation. Specific sections are:
Section 2, “RT3210 Radio Data Terminal”
Section 3, “RT1100 Radio Data Terminal”
Section 4, “RT1700 Radio Data Terminal”
Section 5, “RT5900 Radio Data Terminal”
Section 6, “PEN*KEY 6400 Computer”
Section 7, “PEN*KEY 6500 Computer”
The remaining sections do the following:
" Section 8, “Programming,” describes the character
sets, received codes, transmitted codes, and other com-
mands the wireless station supports. This section also
describes how to set local editing mode (a feature of
the VT330/VT340 terminal), and how to create forms.
" Section 9, “Extended Commands,” describes the
extended commands that print, scan bar codes, and
send communications over the wireless station’s
RS-232 port.
" Appendix A contains bar code scanning information.
To Next Page
Loading...