Intermec VT220/ANSI - Cursor Control Keys; Table 3-3 RT1100 Editing Keys

To Next Page

To Previous Page

SECTION 3 " RT1100 Radio Terminal

3-12 VT220/ANSI Terminal Emulation Programmer’s Reference Guide

Table 3-3

RT1100 Editing Keys

To Do Editing Operation Press

Find [GOLD]+[4]

Insert here [GOLD]+[5]

Remove [GOLD]+[6]

Select [GOLD]+[1]

Prev screen [GOLD]+[2]

Next screen [GOLD]+[3]

Cursor Control Keys

The following chart describes how to use the radio terminal

to do VT220 terminal cursor control.

To Do Cursor Key Press

[Y]

[B]

[A]

["]

In addition to sending VT220 cursor control sequences, the

arrow keys at the top of the keyboard allow you to move the

cursor through the radio terminal’s display. The keys oper-

ate in a local windowing mode, which is enabled with the

black shift or gold shift key.

This mode provides a “window” into the VT220’s screen and

allows you to move the radio terminal’s display window

(Figure 3-2). Each key moves the window in the direction

indicated by the arrow.