Intermec VT220/ANSI - Table 9-6 Tone Options

SECTION 9 " Extended Commands
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 9-29
Table 9-6
Tone Options
Line 1, Columns 2--12
Column Character Description
2 # Extended command.
3 T Tone command.
4--6
(Spaces
000--255
Tone volume.
No change from current setting.
Volume range. The larger the num-
ber, the louder the volume.
7--9
(Spaces)
000--030
Tone frequency.
No change from current setting.
Frequency range. The larger the
number, the higher the frequency.
10--12
(Spaces)
001--010
Tone length.
No change from current setting.
Duration in seconds. The larger the
number, the longer the beep and the
slower the keyboard response time.
The return code is the status sent to the host computer; the
code indicates if the extended command was successful.
The wireless station returns data and the extended com-
mand’s status to the host computer in the following format:
\\X<CR>
“X” is the return code listed in the following chart.
Code Description Column
0 Good status, transaction complete. (None)
8 Incorrect setting for volume. 4--6
9 Incorrect setting for frequency. 7--9
A Incorrect setting for length. 10--12