SECTION 7 " PEN*KEY 6500 Computer
7-10 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
Operation of the delete key [ ] depends on how the
PROTOCOL OPTS parameter is set in the PEN*KEY com-
puter’s firmware. The key either sends a delete (DEL, 7F
hexadecimal) or a backspace (BS, 08 hexadecimal).
To change from delete mode to backspace mode, open the
firmware by pressing [Gold]+[M]. Then select the following
options in this order: SET-UP PARMS (password:
CR52401), PROTOCOL OPTS, VT220, DEL TO BS.
Table 7-2
PEN*KEY 6500 Special Function Keys
To Do Operation Press
Delete
Forward Tab
Reverse Tab
Return [Enter]
Ctrl [Blue]
Lock [Caps Lock]
Shift (uppercase characters) [Shift]
Space bar [Space bar]
Compose character Not supported
Editing Keypad
The VT220 terminal’s editing keypad has editing keys and
cursor control keys. Editing keys have functions assigned
to them by the application software in use. Refer to your
application’s software manual for the uses of the editing
keys. You can use the arrow keys to move the cursor and
page through the PEN*KEY computer’s display.
To Next Page
Loading...