SECTION 2 " RT3210 Radio Terminal
2-16 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
Transmission Mode
Use the transmission mode (labeled “mode” on the overlay)
to put the radio terminal into line edit (block) mode or char-
acter mode. To alternate between modes, press
[FUNC]+[Z]. The modes are described on pages 8-55 and
8-56 in Section 8, “Programming.”
When “lock mode” is disabled through the firmware menus,
you can press the mode key to toggle between line edit
mode and character mode. When lock mode is enabled, you
cannot toggle between line edit (block) mode and character
mode. The default setting is “disabled.”
Backlight
Use the backlight to read the radio terminal’s display in
dim light. To turn the light on, press [FUNC]+[Y]. To turn
it off, press [FUNC]+[Y] again.
You can use the firmware’s setup menus to set the length of
time the backlight stays on before the radio terminal “goes
to sleep” to conserve power. Refer to the radio terminal’s
user’s guide for more information about backlighting.
"
NOTE: The longer the backlight stays on, the sooner the battery will need to
be recharged.
To Next Page
Loading...