SECTION 6 " PEN*KEY 6400 Computer
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 6-17
Table 6-5
PEN*KEY 6400 Editing Keys
To Do Editing Operation Press
Find [GOLD]+[4]
Insert here [GOLD]+[5]
Remove [GOLD]+[6]
Select [GOLD]+[7]
Prev screen [GOLD]+[8]
Next screen [GOLD]+[9]
Cursor Control Keys
The following chart describes how to do VT220 terminal
cursor control operations on the 51-key and 41-key key-
boards.
To Do Cursor Key Press 6400 Key
-
[Y]
¯
[B]
¬
[A]
®
["]
In addition to sending VT220 cursor control sequences, the
arrow keys at the tops of the keyboards allow you to move
the cursor through the PEN*KEY computer’s display. The
keys operate in a local windowing mode, which is enabled
with the blue shift or gold shift key. This mode provides a
“window” into the VT220’s screen and allows you to move
the PEN*KEY computer’s display window (Figure 6-3).
Each key moves the window in the direction indicated by
the arrow.
To Next Page