SECTION 8 " Programming
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 8-45
Identification
The identification sequence is not recommended. The wire-
less station supports the identification sequence
(Table 8-29).
Table 8-29
Identification
Name
(Mnemonic) Sequence Wireless Station Action
Identification
(DECID)
ESC Z Ignores this code.
Terminal Reset
Terminal reset escape sequences cause either a soft termi-
nal reset or a hard terminal reset. Table 8-30 shows the ac-
tion taken by the wireless station when it receives terminal
reset sequences.
Table 8-30
Terminal Reset
Name
(Mnemonic) Sequence Wireless Station Action
Soft terminal re-
set (DECSTR)
CSI ! p Ignores this code.
Hard terminal
reset (RIS)
ESC c Performs a communications
line disconnect.
Clears the display.
Returns the cursor to the up-
per-left corner of the display.
Sets the SGR state to normal.
Sets all character sets to the
default.
To Next Page
Loading...