SECTION 7 " PEN*KEY 6500 Computer
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 7-11
Editing Keys
Table 7-3 describes how to use the PEN*KEY computer to
do VT220 terminal editing operations.
Table 7-3
PEN*KEY 6500 Editing Keys
To Do Editing Operation Press
Find [Gold]+[4]
Insert here [Gold]+[5]
Remove [Gold]+[6]
Select [Gold]+[7]
Prev screen [Gold]+[8]
Next screen [Gold]+[9]
Cursor Control Keys
Use the four cursor control keys (arrows) in the lower right
corner of the keyboard to move the cursor and page through
the PEN*KEY computer’s display. The keys operate in a
local windowing mode, which is always enabled. The mode
provides a “window” into the VT220’s screen and allows you
to move the PEN*KEY computer’s display window
(Figure 7-2). Each key moves the window in the direction
indicated by the arrow.
To Next Page