SECTION 9 " Extended Commands
9-28 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
Return Code for Return Version
The return code is the status sent to the host computer; the
code indicates if the extended command was successful.
The wireless station returns data and the extended com-
mand’s status to the host computer in the following format:
\\0\<Firmware> <Version><CR>
“0” is the return code listed in the following chart.
“<Firmware>” is the name of the wireless station’s firm-
ware.
“<Version>” is the current firmware version.
Code Description
0 Good status, transaction complete.
Example of Return Version
The following example shows data started by the control
character sequence for APC. The sequence is prefixed by
the notation “ ^ ” which represents “control.”
^9F#V^9C
Column 2
Tone (#T)
The Tone extended command causes the wireless station to
make a tone of a specified volume, frequency, and length
(Table 9-6).
To Next Page
Loading...