SECTION 8 " Programming
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 8-5
Table 8-2
C0 Control Characters and Wireless Station Action
Mne-
monic Hex Name Wireless Station Action
NUL 00 Null Ignores this code.
SOH 01 Start of heading Ignores this code.
STX 02 Start of text Ignores this code.
ETX 03 End of text Ignores this code.
EOT 04 End of transmission Ignores this code.
ENQ 05 Enquiry Generates an answerback message. You set
the number of characters in the message
(0--30) through the wireless station’s firmware.
ACK 06 Acknowledge Ignores this code.
BEL 07 Bell Generates bell tone if bell is enabled.
BS 08 Backspace Moves cursor one column to the left. If cursor
is in Column 1, takes no action.
HT 09 Horizontal tab Moves cursor to predetermined tab stop.
Moves cursor to right margin if there are no
tab stops.
LF 0A Line feed Causes a line feed or new line operation, de-
pending on how the LNM received code is set.
VT 0B Vertical tab Processes as LF (line feed).
FF 0C Form feed Processes as LF (line feed).
CR 0D Carriage return Moves cursor to Column 1 of the current row.
SO
(LS1)
0E Shift out
(Lock shift G1)
Invokes G1 character set into GL.
SI
(LS0)
0F Shift in
(Lock shift G0)
Invokes G0 character set into GL.
DLE 10 Data link escape Ignores this code.
To Next Page
Loading...