SECTION 9 " Extended Commands
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 9-3
Control character sequences for mnemonics APC (applica-
tion program command) and ST (string terminator) can also
start and end data. The last data character must be a “#”
(pound sign). The wireless station sends the data to the
RS-232 port until it detects a “#” character and the string
terminator sequence.
The output stream appears in ASCII character format. For
bytes that are not displayable ASCII characters, you may
insert the characters “=yy,” where “yy” is the hexadecimal
representation of the output byte.
Table 9-1 lists columns in which characters must appear.
To Next Page
Loading...