Intermec VT220/ANSI - Page 224

SECTION 9 " Extended Commands
9-18 VT220/ANSI Terminal Emulation Programmer’s Reference Guide
Table 9-3 (Continued)
Receive Only Characters
Line 1, Columns 2--24
Column DescriptionCharacter *
13--14
dd (or)
Xd¼dX
Maximum characters to receive.
“dd” is a decimal digit from 00--99. Default is 99.
“X” is an uppercase literal. “d¼d” is any number of deci-
mal digits from 0--2000 inclusive. Default is 99.
15--16
AA
Delimiter character.
Hexadecimal ASCII code which marks the end of valid
data to be received. Range is 00--7E. Default is 00.
17--18
XX
Number of delimiter characters.
Delimiter characters received before transmitting return
code to host. Range is 00--99. Default is 00.
19--20
AA
Start character.
Hexadecimal ASCII code for start character. Range is
00--99. Default of 00 implies no start character.
21
F
(Space)
Return start character to host.
Return character.
Do not return character.
22
P
(Space)
Flag parity errors.
Flag.
Do not flag.
23--24
XX
Receive timeout length.
Number of seconds the wireless station waits for input
from the RS-232 port before it sends a timeout error.
Uses a default of 5 seconds when this field is filled with
spaces.
* Some wireless stations do not support some characters. Refer to the wireless
station’s user guide for supported characters and options.