SECTION 9 " Extended Commands
VT220/ANSI Terminal Emulation Programmer’s Reference Guide 9-21
Column Character Description
1 (Space) This column typically contains a space.
2 # Extended command.
3 G Receive Only command.
4 3 4800 baud.
5 N No data parity.
6 8 Eight data bits.
7 1 One stop bit.
8 (Space) Reserved.
9 (Space) Reserved.
10 (Space) Reserved.
11--12 (Spaces) Reserved.
13--14 50 Receive a maximum of 50 characters.
15--16 0A Delimiter character is 0A hexadecimal
(line feed).
17--18 01 Data will be sent to host after one de-
limiter character has been received.
19--20 02 Start character is 02 hexadecimal
(STX).
21 F Start character will be returned to host.
22 P Parity errors will be flagged
23--24 10 Receive timeout length is 5 seconds.
Set Parameters (#H)
Use the Set Parameters extended command to set firmware
parameters that you would otherwise set at the wireless
station. The parameters are part of the wireless station’s
firmware.
Set most of the parameters once per wireless station. Set
them when you install a radio data network, or when you
add wireless stations to the network. Unless the wireless
station fails (perhaps a dead battery) or a user does some-
thing destructive (like a RAM test), you probably won’t
need to set them again.
To Next Page
Loading...