ISCO 6700SR - Page 143

6700SR Refrigerated Sampler
125
Figure 41 Extended Programming: Hardware Quick View Screens
MASTER/SLAVE ON
BTL FULL DETECT OFF
TIMED BACKLIGHT
PGM LOCK ENABLED
RUN "ISCO 6700 "
PROGRAM
VIEW REPORT
OTHER FUNCTIONS
MAINTENANCE
MANUAL FUNCTIONS
PROGRAMMING STYLE
HARDWARE
AT THE BEGINNING OF:
INITIAL PURGE
FORWARD PUMPING
DURING:
ENTIRE PUMP CYCLE
FORWARD PUMPING
BACKLIGHT ALWAYS OFF
TIMED BACKLIGHT
CONTINUOUS BACKLIGHT
EVENT MARK DURATION
3 SECONDS
WHILE PUMPING
PRE-SAMPLE PURGE:
____ COUNTS
(10-9999)
POST-SAMPLE PURGE:
DEPENDENT ON HEAD
FIXED COUNT
POST-SAMPLE PURGE:
____ COUNTS
(10-9999)
EVENT MARK SENT
WHILE
PUMPING FORWARD
PUMP COUNTS FOR
EACH PURGE CYCLE:
____ PRE-SAMPLE
____ POST-SAMPLE
I/O1=I/O ENABLE
I/O2=PGM RUNNING
I/O3=PROGRAM DONE
MASTER/SLAVE?
YES NO
See Note B.
See Note A.
See Note A.
LIQUID DETECTION
0.01 inch TIP
RAIN GAGE
DO YOU HAVE A
RAIN GAGE CONNECTED?
YES NO
RAIN GAGE
0.01 inch TIP
0.1mm TIP
NEW HARDWARE SETUP--
STORED DATA WILL
BE LOST! OK?
YES NO
YES
NO
YSI 600
Y-pH Y-D.O. Y-COND
Y-TEMP
If applicable
BOTTLE FULL DETECT?
YES NO
EVENT MARK SENT FOR
EVERY SAMPLE
COMPLETE SAMPLES
USE LIQUID DETECTOR?
YES NO
Notes
A. Option only appears when the program option is activated. See
Chapter 6.
B. <- denotes input signal.
-> denotes output signal.
CHANGE PASSWORD TO
_____
REENTER NEW PASSWORD
_____
YSI 600
OTHER YSI SONDE
NO YSI SONDE
RUN FLOW THRU PUMP
___SECONDS BEFORE
TAKING READINGS
(0-120)
SET I/Ox:
NONE
<- I/O ENABLE
<- FR-TEMP
-> PGM RUNNING
-> PGM ENABLED
-> 'A' ENABLED
-> 'B' ENABLED
-> PROGRAM DONE
-> 'A' DONE
-> 'B' DONE
-> RUN ERROR
-> FLOW THRU
-> CONDITIONS
NEW HARDWARE SETUP--
STORED DATA WILL
BE LOST! OK?
YES NO
See
Figure 42
, Extended Programming:
YSI 600 Screens
, on page 126.
See
Figure 45
, Analog Output and Dialout
Quick View Screens
, on page 128.
See
Figure 43
, Extended Programming:
Optional YSI Screens
, on page 127.
See
Figure 39
on page 123.