Mounting and commissioning
USER MANUAL FPC 200 - 3/2017 151
5.3 Equipment identification and unpacking
When removing the packaging the user is obliged to carefully inspect the device for any physical damage. Damaged
device should be returned to supplier together with the original packaging. Device that is damaged should not be
connected to power supply or put to commission.
Package specification
Each FPC 200 is delivered in a single package. Optional accessories such as modules and connectors are delivered in
separate packages.
Single package specifications
Table 111 Package specification. *Maximum weight depends on order configuration.
Device identification
Device is identified by reading the label on package and device itself. Identification label is attached at the right side of
the device as shown on Figure 5.1. The label indicates the product model, serial number, firmware revision, and date of
manufacture. Additional label is provided to be placed in more convenient location if the need arises.
Figure 5.1: Side view where label is attached
Additional label is included.
To Next Page
Loading...
Need help?
General
