Content
2 USER MANUAL FPC 200 - 3/2017
Preface
Copyright
Copyright © Iskra d.d. Ljubljana, Slovenia 2016. All rights reserved. Dissemination or reproduction of this document, or
evaluation and communication of its contents is not authorized except where expressly permitted.
Purpose of this manual
The manual describes the functionality, as well as operation, installation and commissioning instructions for the FPC 200
types F1, F3, M1, M3, B2, B3, T1 and T3.
Target audience
Protection engineers, mechatronic engineers, commissioning engineers, personnel concerned with setting, monitoring
and service of protection equipment, industrial automatic and control facilities and personnel of electrical facilities and
power plants.
Applicability
This manual is valid for all FPC 200 type multifunctional numerical relays.
Conformity
This product complies with the Low Voltage Directive 2014/35/EU and EMC Directive 2014/30/EU. This
conformity has been proved by tests according to product standards IEC 60255-26 (for EMC directive)
and IEC 60255-27 (for Low Voltage Directive).
Liability statement
Specialists and responsible persons of Iskra d.d. has checked the contents of this manual to ensure the description of both
hardware and software are as accurate as possible. However, deviations from the description cannot be completely ruled
out, so that no liability can be accepted for any errors or failures contained in the given manual. The content of this
manual is reviewed regularly. Corrections will be included in following editions. Any suggested improvements are highly
appreciated. We reserve the right to make technical improvements without notice.
To Next Page
Loading...
Need help?
General
