Iskra FPC 200 - Parameters

Communication
USER MANUAL FPC 200 - 3/2017 107
Parameters
The following parameters needs to be set for the communication to be established properly
Parameter
Range
Description
Protocol
ModbusRTU
IEC103
Selection of active communication protocol.
Device address
0 … 33 … 254
Number by each slave device is uniquely addressed.
Baud rate
1200
2400
4800
9600
19200
38400
57600
115200
Defines the number of binary information to be transmitted per second.
Parity
Even
Adds an error checking bit that follows the data bits in the character
frame.
Stop bits
1
Number of stop bits after each character frame.
Data bits
8
Number of data bits in each character frame.
Table 105 Parameters of Modbus RTU communication protocol.