Mounting and commissioning
148 USER MANUAL FPC 200 - 3/2017
5 Mounting and commissioning
This chapter is intended for experienced commissioning staff. Typical procedures during commissioning of the device are
described. The staff must be familiar with commissioning of protection and control systems, management of power
systems and relevant safety rules and guidelines. Knowledge of the project, device and necessary tools is required.
5.1 Safety instructions .............................................................................................................................................. 149
5.2 Precautions ......................................................................................................................................................... 149
5.3 Equipment identification and unpacking ............................................................................................................ 151
5.4 Device installation ............................................................................................................................................... 152
5.5 Connection .......................................................................................................................................................... 156
5.6 External module .................................................................................................................................................. 160
5.7 Commissioning .................................................................................................................................................... 162
To Next Page
Loading...