Iskra FPC 200 - Parameters

Communication
84 USER MANUAL FPC 200 - 3/2017
3.1.5.4 Remote deletion of events
Monitoring system has the ability to delete all events in
the device, in the buffer and in the analogue table, by
writing control word which has the number of events
set to FF. In this case, the number of transactions is
reset to 0.
Parameters
The following parameters needs to be set for the communication to be established properly
Parameter
Range
Description
Protocol
Modbus RTU
IEC103
Selection of active communication protocol.
Device address
0 … 33 … 247
Number by each slave device is uniquely addressed.
Baud rate
1200
2400
4800
9600
19200
38400
57600
115200
Defines the number of binary information to be transmitted per second.
Parity
None
Odd
Even
Adds an error checking bit that follows the data bits in the character
frame.
Stop bits
1
2
Number of stop bits after each character frame.
Data bits
8
9
Number of data bits in each character frame.
Table 87 Parameters of Modbus RTU communication protocol.