Chapter 6
Controller V6 Touch
Page 108 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
V6 Temperature Module PN 115735
The V6 TEMP module(s) is mounted next to the V6 Base Module on the Din-rail. It
requires 24VDC supply voltage. It is responsible for the temperature control of all heated
temperature zones. The RTD temperature sensors connect to this module and the TEMP
module provides corresponding output signals to the power boards. Depending on the
configuration of the ASU, the RTDs may be PT100 (DynaControl) or NI120 (Nordson).
Configuration is determined by a jumper located within the module (see below, to left of
module illustration).
Each of the maximum 15 zones has a status LED which shows its heating status in the
following manner:
• if the zone is switched off, the LED is Off,
• if the zone is heating, the LED is On,
• if the zone is near or at the setpoint temperature, the LED blinks.
To Next Page
Loading...
