ITW Dynatec DM55 DynaDrum - Customer Zone Names

ITW Dynatec
Chapter 6
Controller V6 Touch
Page 86 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
Customer Zone Names
 To go to this screen, press the General Settings button on the Settings Screen.
 Use the Customer Zone Names Editor program (provided on CD) and a thumb drive (not
provided) to make changes.
Item Description
1
Parameter Selection tabs
The Customer Zone Names tab has been selected.
2
Customer Zone Names
If activated, you can Load or Erase Zone Names by pressing the appropriate button.
With the Customer Zone Names feature, the user may personalize the names of the
temperature zones with names that are more descriptive for his application.
A CD with the Customer Zone Names Editor program is supplied with your unit. The program
allows the character sets of many different languages. To utilize this feature:
1. Install the program from the CD into your computer.
2. Write your personalized zone names in this program.
3. Load your personalized program onto a thumb drive.
4. Insert the thumb drive into the V6 touch panel.
5. Load the new names into the controller by pressing “Load Zone Names” on the
Customer Zone Names screen (seen above).
6. Activate the names by pressing “Activate Customer Zone Names”.
Later you may deactivate (or re-activate) the names by pressing “Activate Customer Zone
Names” again. When personalized names are deactivated, the ITW Dynatec default zones
names become active.
You may also press Erase Zone Names to delete your loaded zone names and you may load
a new group of names utilizing the Customer Zone Names Editor program again.
6
7
1
2
4
5
3