Chapter 6
Controller V6 Touch
Page 56 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
Pump Overview Screen
To go to this screen, press the Pumps button on the Main Screen.
While on the Pump Overview Screen, all changes are immediate (you do not need to confirm).
The Pump Overview Screen allows you to program the pump mode (Manual, Stop or Automatic).
Each pump in the system must be programmed with a Pump Mode.
Decentralized pumps (e.g. Applicator, Metering Station: A plausible limit value of Input
Pressure (a minimum pressure of not less than 2 bar is recommended) has to be entered to avoid
a dry run of the pumps; otherwise the pump can be damaged. See point “Extended Pump Mode
Settings Screen, Linear Line Speed, Pressure Control” on next pages.
To Next Page
Loading...
