ITW Dynatec DM55 DynaDrum - Automatic Ramp Compensation at DM55 with Gear Pump

ITW Dynatec
Chapter 6
Controller V6 Touch
Page 64 DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19
Automatic Ramp Compensation at DM55 with Gear Pump
 To go to this screen, press the Automatic Ramp Compensation button on the Extended Pump
Mode Settings Linear Line Speed screen.
 The Automatic Ramp Compensation screen allows you to program parameters in order to
compensate the adhesive amount when the speed of the main machine accelerates and
decelerates.
With Linear Pump Control (Line Speed without Pressure PID Loop):
With Pressure Control PID Loop:
1
4
2
3
5
6