Chapter 9
Drawings and Bill of Materials
DM55 DynaDrum PP V6, Manual No.21-18, Rev.2.19 Page 141
Chapter 9
Drawings and Bill of Materials
Notes
All parts must be periodically inspected and replaced if worn or broken. Failure to
do this can affect equipment’s operation and can result in personal injury.
This chapter contains the component illustrations (exploded-view drawings) for each
assembly of the ITW Dynatec DM55 DynaDrum Bulk Adhesive Melter. These drawings
are useful for finding part numbers as well as for use when maintaining or repairing the
unit.
Note: Most common screws, nuts and washers called out in the manual are not for sale
and they can be obtained locally at your hardware Store. Specialty fasteners are
available by contacting ITW Dynatec’s Customer Service.
To Next Page
Loading...